In a closed traverse, ABC, the bearings of two lines AB and BC are given.
Line Length (m) Bearing AB 100 90° BC 120 150°
The length, in m and bearing of line CA, in degree, respectively, are
| Line | Length (m) | Bearing |
| AB | 100 | 90° |
| BC | 120 | 150° |
The length, in m and bearing of line CA, in degree, respectively, are
- 190.7 and 303°
- 190.7 and 240°
- 160.3 and 240°
- 160.3 and 303°
The Correct Option is A
Solution and Explanation
Top Questions on Trusses and Frames
An idealised frame supports a load as shown in the figure. The horizontal component of the force transferred from the horizontal member PQ to the vertical member RS at P is N (round off to one decimal place).
- GATE CE - 2023
- Engineering Mechanics
- Trusses and Frames
An idealised frame supports a load as shown in the figure. The horizontal component of the force transferred from the horizontal member PQ to the vertical member RS at P is N (round off to one decimal place).}
- GATE CE - 2023
- Engineering Mechanics
- Trusses and Frames
- Which of the following statement(s) is/are correct?
- GATE CE - 2022
- Engineering Mechanics
- Trusses and Frames
Questions Asked in GATE MN exam
Reciprocal levelling is performed for points P and Q by placing the same levelling instrument at A and B. The observations of staff readings are tabulated as below.
If the Reduced Level (RL) of P is 115.246 m, then the true RL of Q, in m, is _______ (rounded off to 3 decimal places)
- GATE MN - 2025
- Surveying
- SO$_2$ is emitted at a rate of 20 kg/s from a 10 km $\times$ 10 km airshed in an industrial area. Wind blows at a speed of 4 m/s from one direction in that area. Radiation inversion restricts the mixing height to 1200 m. Neglect SO$_2$ concentration in the incoming air. Assuming emitted SO$_2$ to be conservative, the steady state SO$_2$ concentration in the airshed, in $\mu g/m^3$, is _______ (rounded off to 2 decimal places).
- GATE MN - 2025
- Environmental Engineering
- In a longwall panel, air flows at a velocity of 1.2 m/s through a 900 m long gate road of 2.5 m height and 3 m width. The coefficient of friction is 0.022 Ns$^2$m$^{-4}$. The frictional pressure drop, in Pa, between two ends of the gate road is _______ (rounded off to 3 decimal places).
- GATE MN - 2025
- Fluid Mechanics
The information of a mining project for a life of three years is given below:
Additional data: Applicable tax rate = 30%
Discount rate = 10%
Depreciation method: Straight line with zero salvage value- GATE MN - 2025
- Mine planning and its components
Data from a borehole log with collar elevation at 590 mRL are given below. Composite grade is calculated using cores of 5 m above and below the reference bench at 580 mRL. The composite grade, in %, is:
- GATE MN - 2025
- Mine planning and its components