Question:
A typical 24-hour activity of a mobile crusher plant is shown. The utilization, in %, of the plant, is (round off up to 2 decimals)
A typical 24-hour activity of a mobile crusher plant is shown. The utilization, in %, of the plant, is (round off up to 2 decimals)
Updated On: Sep 6, 2024
Hide Solution
Verified By Collegedunia
Correct Answer: 85
Solution and Explanation
The correct answer is: 85.00 or 86.00 (approx)
Was this answer helpful?
0
1
Top Questions on Optimization of Facility Location
- A solid ball of mass 10 kg is subjected to forces as shown. The magnitude of the acceleration in m/s2, is____.(round off up to 2 decimals)
- GATE MN - 2024
- Mine Planning
- Optimization of Facility Location
- The spherical semivariogram model (γ(h)) is represented by the following expression, where h is the lag distance.
\(y(h) = \begin{cases} C_0,\\ C_0+(C-C_0)[1.5\frac{h}{a}-0.5(\frac{h}{a})^3], &\\C, \end{cases}\)
The parameters Co, C and a are respectively known as- GATE MN - 2024
- Mine Planning
- Optimization of Facility Location
Questions Asked in GATE MN exam
- A Bord and Pillar panel is developed at a depth of 250 m in a flat coal seam. The vertical stress gradient is 0.027 MPa/m. If the strength of a square pillar is 12.5 MPa, the extraction ratio of the pillar for a safety factor of 1.5, is____.(round off up to 2 decimals)
- GATE MN - 2024
- Room and pillar mining
- Water is pumped from a mine sump at the rate of 300 m3/hr to an inverted conical water tank, as shown. The rate of rise in water level in m/min, at the instant water level reaches at 5 m height from bottom of the tank, is____.(round off up to 2 decimals)
- GATE MN - 2024
- Levels and Levelling
- A mine worker weighing (W) 600 N lifts an object of 100 N as shown. The 50% body weight is applied downward through point A and a force FE is produced parallel to x axis by the contraction of erector spinae muscle during lifting. The lumber disc, L (shown by red box) acts as a smooth hinge and keeps the upper body in static equilibrium. Ignore all other forces in the body. The magnitude of the resultant of the reaction forces, in N at the lumber disc, is____.(round off up to 2 decimals)
- GATE MN - 2024
- Mechanization of Surface Mining
- In an opencast coal mine, blast vibrations are measured at two locations, A and B simultaneously for a maximum charge per delay (Q) of 1200 kg as given.\(PPV=K[\frac{D}{\sqrt{Q}}]^{-B}\)
Location Distance from the blast face, D (m) PPV (mm/s) A 100 112.5 B 300 20.3
where, K and ẞ are site constants. The PPV in mm/s, at a distance of 200 m from the blast face, is (round off up to 2 decimals)- GATE MN - 2024
- Ground Vibrations
- In a development coal face, 12 holes are drilled and charged with explosive. Holes are initiated with electric delay detonators connected in series. The length of a detonator lead wire is 1.5 m. The length of the blasting cable is 120 m.
Data are as given:
Resistance of each detonator : 1.48 Ω
Resistance of lead wire : 0.04 Ω/m
Resistance of one wire of the blasting cable : 0.009 Ω/m
The total resistance of the circuit in , is____.(round off up to 2 decimals)- GATE MN - 2024
- Underground Coal Mining
View More Questions