Question:
A transportation system for carrying ore from stock pile to railway siding through an ore bin is shown. The time between failure of each conveyor belt follows an exponential distribution with mean time between failure of 700 hours. The system is considered to be a 'success' if ore transports from stock pile to siding by any combination of belts. The reliability of the system for 350 hours of continuous successful operation, is_____.(round off up to 2 decimals)
A transportation system for carrying ore from stock pile to railway siding through an ore bin is shown. The time between failure of each conveyor belt follows an exponential distribution with mean time between failure of 700 hours. The system is considered to be a 'success' if ore transports from stock pile to siding by any combination of belts. The reliability of the system for 350 hours of continuous successful operation, is_____.(round off up to 2 decimals)
Updated On: Jul 18, 2024
Hide Solution
Verified By Collegedunia
Correct Answer: 0.7
Solution and Explanation
The correct answer is: 0.70 or 0.72 (approx)
Was this answer helpful?
0
0
Top Questions on Transportation of Surface Mining
- A 35.0 kW motor transmits power to a pulley of 600 mm diameter, which rotates at 400 rpm to drive a flat belt. The tension in the tight side is 2.5 times of the slack side. Neglect all transmission losses. If the maximum allowable tension is 8.0 N per mm of belt width, then the minimum width of the belt in mm, is____.(round off up to 2 decimals)
- GATE MN - 2024
- Mining Methods and Machinery
- Transportation of Surface Mining
Questions Asked in GATE MN exam
- A Bord and Pillar panel is developed at a depth of 250 m in a flat coal seam. The vertical stress gradient is 0.027 MPa/m. If the strength of a square pillar is 12.5 MPa, the extraction ratio of the pillar for a safety factor of 1.5, is____.(round off up to 2 decimals)
- GATE MN - 2024
- Room and pillar mining
- Water is pumped from a mine sump at the rate of 300 m3/hr to an inverted conical water tank, as shown. The rate of rise in water level in m/min, at the instant water level reaches at 5 m height from bottom of the tank, is____.(round off up to 2 decimals)
- GATE MN - 2024
- Levels and Levelling
- A mine worker weighing (W) 600 N lifts an object of 100 N as shown. The 50% body weight is applied downward through point A and a force FE is produced parallel to x axis by the contraction of erector spinae muscle during lifting. The lumber disc, L (shown by red box) acts as a smooth hinge and keeps the upper body in static equilibrium. Ignore all other forces in the body. The magnitude of the resultant of the reaction forces, in N at the lumber disc, is____.(round off up to 2 decimals)
- GATE MN - 2024
- Mechanization of Surface Mining
- In an opencast coal mine, blast vibrations are measured at two locations, A and B simultaneously for a maximum charge per delay (Q) of 1200 kg as given.\(PPV=K[\frac{D}{\sqrt{Q}}]^{-B}\)
Location Distance from the blast face, D (m) PPV (mm/s) A 100 112.5 B 300 20.3
where, K and ẞ are site constants. The PPV in mm/s, at a distance of 200 m from the blast face, is (round off up to 2 decimals)- GATE MN - 2024
- Ground Vibrations
- A solid ball of mass 10 kg is subjected to forces as shown. The magnitude of the acceleration in m/s2, is____.(round off up to 2 decimals)
- GATE MN - 2024
- Optimization of Facility Location
View More Questions