Question:
A circular tunnel is constructed at a depth of 100 m. The average unit weight of overburden rock is 27.0 kN/m3. If the tangential stress measured at point A located at the horizontal boundary of the tunnel as shown, is 5.0 MPa, the tangential stress at point B in MPa, is____.(round off up to 2 decimals)
A circular tunnel is constructed at a depth of 100 m. The average unit weight of overburden rock is 27.0 kN/m3. If the tangential stress measured at point A located at the horizontal boundary of the tunnel as shown, is 5.0 MPa, the tangential stress at point B in MPa, is____.(round off up to 2 decimals)
Updated On: Jul 18, 2024
Hide Solution
Verified By Collegedunia
Correct Answer: 6
Solution and Explanation
The correct answer is: 6.00 or7.00 (approx)
Was this answer helpful?
0
0
Top Questions on Stress Measurement Techniques
- Mohr-Coulomb envelop between shear stress, τ and normal stress, σn of a sandstone rock is given as
τ=7.5+0.84 on (unit of stresses is MPa)
A sandstone sample is tested in triaxial mode with confining pressure of 5.0 MPa. The value of the shear stress, τ in MPa at the failure, is____.(round off up to 2 decimals)- GATE MN - 2024
- Geomechanics and Ground Control
- Stress Measurement Techniques
Questions Asked in GATE MN exam
- A Bord and Pillar panel is developed at a depth of 250 m in a flat coal seam. The vertical stress gradient is 0.027 MPa/m. If the strength of a square pillar is 12.5 MPa, the extraction ratio of the pillar for a safety factor of 1.5, is____.(round off up to 2 decimals)
- GATE MN - 2024
- Room and pillar mining
- Water is pumped from a mine sump at the rate of 300 m3/hr to an inverted conical water tank, as shown. The rate of rise in water level in m/min, at the instant water level reaches at 5 m height from bottom of the tank, is____.(round off up to 2 decimals)
- GATE MN - 2024
- Levels and Levelling
- A mine worker weighing (W) 600 N lifts an object of 100 N as shown. The 50% body weight is applied downward through point A and a force FE is produced parallel to x axis by the contraction of erector spinae muscle during lifting. The lumber disc, L (shown by red box) acts as a smooth hinge and keeps the upper body in static equilibrium. Ignore all other forces in the body. The magnitude of the resultant of the reaction forces, in N at the lumber disc, is____.(round off up to 2 decimals)
- GATE MN - 2024
- Mechanization of Surface Mining
- In an opencast coal mine, blast vibrations are measured at two locations, A and B simultaneously for a maximum charge per delay (Q) of 1200 kg as given.\(PPV=K[\frac{D}{\sqrt{Q}}]^{-B}\)
Location Distance from the blast face, D (m) PPV (mm/s) A 100 112.5 B 300 20.3
where, K and ẞ are site constants. The PPV in mm/s, at a distance of 200 m from the blast face, is (round off up to 2 decimals)- GATE MN - 2024
- Ground Vibrations
- A solid ball of mass 10 kg is subjected to forces as shown. The magnitude of the acceleration in m/s2, is____.(round off up to 2 decimals)
- GATE MN - 2024
- Optimization of Facility Location
View More Questions